Energy regeneration?

[badger]

Is there any way to disable the need for the energy regeneration setting? What I mean is, I know we can dial up the number so it regenerates fatser, but is there some way to set TNM so that guys can wrestle two matches on a card and start 100% on match two?

I run unbooked and there are times when I'll have a mini tournament on a card where the winners of the first two matches on the show face each other in the main and even if regeneration is set to 100, and there are filler matches in between, someone invariably starts that main event match at 35-50% health and I get a 4 minute match, which sucks.

Thanks!!!

[tnmlyger]

This currently doesn't exist but I'll add it as an option over the next few days.

[badger]

Thanks!

[tnmlyger]

Sorry this is delayed. I've been editing AEW Dynamite and AEW Rampage for some international markets these last two weeks and it's been a bit of a whirlwind, leaving very little time for anything else. I'll get to it mid-week.

[badger]

Sept 25, 2021 16:36:16 GMT -5 tnmlyger said:

Sorry this is delayed. I've been editing AEW Dynamite and AEW Rampage for some international markets these last two weeks and it's been a bit of a whirlwind, leaving very little time for anything else. I'll get to it mid-week.

Whenever you can, no rush at all! I'm just glad you're around supporting this. Thanks again!

[tnmlyger]

I just pushed this change out. Please run the TNM Updater plugin.

Then go into your circuit, press "o" to launch TweakCirc SE, select "Advanced Options 1" and then enter -1 into the "Energy Regeneration" field (negative one).

That should take care of it.

[badger]

Thanks! I'm not running build 13, though, so I don't think I have the updater, right?

[tnmlyger]

That is correct. You'd need to update to Build 13 first. When you install Build 13, it gives you the option to import an older Build's data. The old Build will stay untouched in case you decide to go back.